Current Issue

November 2017, Volume 4, Number 1/2/3/4

Investigation of Hole Quality and Tool Wear in High-Speed Drilling of AL 7050

Edo Suryopratomo1 and Robert Heinemann21Universitas Bakrie, Indonesia and 2University of Manchester, UK

Discovery of Lagrangian Equation for Fluid Mechanics

Shuh Jing Ying, University of South Florida, USA

May 2016, Volume 3, Number 2

Evaluating the Predicted Reliability of Mechatronic Systems: State of the Art
N.Bensaid Amrani, L.Saintis, D.Sarsri and M. Barreau, University of Angers, France

February 2016, Volume 3, Number 1

Using Gis and Remote Sensing Techniques for Solar Hotspots Installation in Thiru Nagar, Dindigul District
N.D.Mani and Penmaya Ningshen, The Gandhigram Rural Institute, India

November 2014, Volume 1, Number 3

A Study of Crankpin Failure in I.C. Engine
M. Senthil kumar1, S.Ragunathan2, M.Suresh1 and V.R.Srinivashan2, 1Sona College of Technology, India and 2Jayalakshmi Institute of Technology, India
Micro Planning And CNC Programming For Cylindrical Part In AMPPS
Shinde B.M1 and Khodke P.M2, 1Dnyanganga College of Engineering & Research, India and 2Government College of Engineering, India

August 2014, Volume 1, Number 2

Analytical Solution for the Temperature Distribution in Cross-Flow Plate Heat Exchanger Channels of Isosceles Triangular Geometry
Rilrada Sangsawang, Thanate Matum and Udomkiat Nontakaew, King Mongkut’s University of Technology North Bangkok, Thailand
Performance Analysis of a Combined Cycle Gas Turbine under Varying Operating Conditions
Dillip Kumar Mohanty and Vijay Venkatesh, Birla Institute of Technology & Science, India
A Methodology for Analysis of Topological Charateristics of Planetary Gear Trains 
S.R.Madan, Sajid Quresh and Mustaq Ptel, Mahakal Institute of Technology and Management, India
Investigation of Spring Back Behavior of SS-304 Steel and its Bi-Layer Material in V Bending
Chintan K. Patel, C.K.Pithawala College of Engineering & Technology, India

May 2014, Volume 1, Number 1

Three-Dimensional Study for the Relative Positioning of Mechanical Elements in Mechanisms Constituted by Parallel Joints with Clearances
Mohamad Younes1, Philippe Dal Santo2 and Alain. Potiron2, 1Lebanese University, Lebanon and 2Ecole Nationale Supérieure d’Arts et Métiers, France
Delamination Behaviour and Experimental Validation of Glass Fabric/Epoxy Matrix and Carbon Fabric/Epoxy Composites in Mode-1 Loading
R.Hemanth and B.Naresh, Vellore Institute of Technology, India
Production Process Analysis on Manufacturing of Hydraulic Gear Pump
J.J.Kathiriya1, V.D.Amareliya2 and S.H.Kapadiya2, 1Shantilal Shah Engineering College, India and 2Gandhi Institute of Technical Education and Research Centre, India
Analysis and Study the Effects of various Control Factors Of Cnc-Wire Cut Edm for S7 Steel
SonuDhiman, RavinderChaudhary and V.K.Pandey,Shri Krishan Institute Of Engineering & Technology, India